€ 49.95
Sin Impuesto: € 41.28
Descripción
Spirit ZigBee is an energy saving controller compatible with the ZigBee wireless standard.
Spirit ZigBee uses the Home Automation Profile 1.2 as a radiator thermostat as an HVAC compatible end device. Depending on the mode, the energy-saving controller can be used as a heater thermostat or, when the control is disabled, it can act as a pure actuator.
The temperature measured by the internal sensor or the position of the valve drive can be reported back to the corresponding gateway via ZigBee.
Features:
- Wireless standard: ZigBee 3.0
- Wireless frequency: 2.4 GHz
- Thermostat control with Echo Plus and Echo Show, without additional gateway
- Quick change of heating times, temperatures, etc.
- Control of the thermostats also from on the road
- Open Window Detection Illuminated LCD display
- Low-noise operation
- Simple mounting and installation
- Control range: 5° C to 30° C
- Response sensitivity: 0.1° C
- Protection class: IP20
Scope of delivery:
- ZigBee energy saving controller,
- Quick Start Guide DE/EN,
- operating instructions (FR, ES, IT, PL),
- 3 adapters (Danfoss RA, RAV, RAVL),
- 2 LR6/Mignon/AA batteries
Especificaciones
| Compatibilidad Controlador Principal | |
|---|---|
| eeDomus+ | |
| Fibaro Home Center 2 v4.160 | Full Compatible |
| Fibaro Home Center Lite v.4.160 | Full Compatible |
| Vera Edge / Plus / Secure | |
| Zipabox/Zipaminicro/ZipaTile | |
| Piper / Piper NV (v.1.7.1) | |
| Indigo | |
| jeedom | |
| Z-Wave.me / Z-Way / PoPP Hub v 3.2.1 | Maximum 4 devices at the same time |
| Domoticz | |
| ZiHome | |
| Somfy Tahoma | |
| Home Assistant | |
| Telldus | |
| Tech Data | |
| IP Rating | IP20 |
| Alimentación | 2 x 1.5V LR6 / AA |
| FLiRS | YES |
| Explorer Frames - NWI Support | YES |
| SDK | 6.71.01 |
| App Version | HW: 49 FW: 0.15:00.08 |
| Device Type | Thermostat - HVAC |
| Z-Wave Alliance Product Link | https://products.z-wavealliance.org/products/2543 |
| Procedimientos | |
| Inclusión | Start Inclusion mode of your primary Z-Wave Controller. Press the Boost-Button. |
| Exclusión | Start Exclusion mode of your primary Z-Wave Controller. Now press and hold the boost button of the Spirit Z-Wave Plus for at least 5 seconds. |
| Factory Reset | Please use this procedure only when the network primary controller is missing or otherwise inoperable. Remove batteries. Press and hold boost button. While still holding boost button insert batteries. The LCD shows RES. Release boost button. To perform the factory reset press boost button. |
| Wake-up (despertar) | |